Step 7 Micro Win Software install#

The first time you use STEP 7, install it and transfer the license keys from diskette to the hard disk (see also Installing STEP 7 and Authorization).Д«efore you work with STEP 7, plan your automation solution from dividing the process into individual tasks to creating a configuration diagram (see also Basic Procedure for Planning an Automation Project). This is recommended for service and maintenance work, for example, to integrate programmed blocks into in an existing project.Д«rief Description of the Individual Steps You can, however, program the blocks first without configuring the hardware. You can configure the hardware first and then program the blocks. It refers you to the relevant chapter thus giving you the opportunity of moving through the manual to find task-related information.ДЄs shown in the figure above, you have two alternative procedures: The following figure shows the tasks that need to be performed for most projects and assigns them to a basic procedure. When you create an automation solution with STEP 7, there are a series of basic tasks. STEP 7 is the subject of this documentation, STEP 7 Micro is described in the 'STEP 7 Micro/DOS' documentation. Opportunity of assigning parameters to function modules and communications processorsД®vent-driven data transfer using communication function blocks STEP 7 for applications on SIMATIC S7-300/S7-400, SIMATICВ M7-300/M7-400, and SIMATICВ C7 with a wider range of functions:Д¬an be extended as an option by the software products in the SIMATIC Industry Software (see also Extended Uses of the STEP 7 Standard Package) STEP 7 Micro/DOS and STEP 7 Micro/Win for simpler stand-alone applications on the SIMATIC S7-200. There are the following versions of the STEP 7 Standard package: It is part of the SIMATIC industry software. STEP 7 is the standard software package used for configuring and programming SIMATIC programmable logic controllers.

Step 7 Micro Win Software